LinuxQuestions.org - Bonding NICS Rhel5

I want to find out if anyone know if a way to determine my bond0 interface speed when ethtool can't retrieve it.

I bonded eth0 and eht1 on Rhel5 AS as bond0. when I bring up the interface it show the info etc. look at the ifconfig info below.

bond0 Link encap:Ethernet HWaddr 00:18:FE:71:C6:AE
inet addr:128.1.1.101 Bcast:128.1.3.255 Mask:255.255.252.0
inet6 addr: fe80::218:feff:fe71:c6ae/64 Scope:Link
UP BROADCAST RUNNING MASTER MULTICAST MTU:1500 Metric:1
RX packets:49442 errors:0 dropped:0 overruns:0 frame:0
TX packets:312 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:4265521 (4.0 MiB) TX bytes:46517 (45.4 KiB)

eth0 Link encap:Ethernet HWaddr 00:18:FE:71:C6:AE
inet6 addr: fe80::218:feff:fe71:c6ae/64 Scope:Link
UP BROADCAST RUNNING SLAVE MULTICAST MTU:1500 Metric:1
RX packets:24725 errors:0 dropped:0 overruns:0 frame:0
TX packets:156 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:2133507 (2.0 MiB) TX bytes:24035 (23.4 KiB)
Interrupt:169 Memory:f8000000-f8011100

eth1 Link encap:Ethernet HWaddr 00:18:FE:71:C6:AE
inet6 addr: fe80::218:feff:fe71:c6ae/64 Scope:Link
UP BROADCAST RUNNING SLAVE MULTICAST MTU:1500 Metric:1
RX packets:24717 errors:0 dropped:0 overruns:0 frame:0
TX packets:156 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:2132014 (2.0 MiB) TX bytes:22482 (21.9 KiB)
Interrupt:177 Memory:fa000000-fa011100

lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:1480 errors:0 dropped:0 overruns:0 frame:0
TX packets:1480 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:2191444 (2.0 MiB) TX bytes:2191444 (2.0 MiB)

-------------------------------

but when I run ethtool on bond0 I get the following messages. FYI bond0 should show up as 2Gbps

[root@smrtora ~]# ethtool bond0
Settings for bond0:
No data available

Any info would be greatly appreciated

Tim