LinuxQuestions.org

LinuxQuestions.org (/questions/)
-   Linux - Embedded & Single-board computer (http://www.linuxquestions.org/questions/linux-embedded-and-single-board-computer-78/)
-   -   Uncompressing Linux... done, booting the kernel then stopped (http://www.linuxquestions.org/questions/linux-embedded-and-single-board-computer-78/uncompressing-linux-done-booting-the-kernel-then-stopped-818835/)

RRNAIR 07-09-2010 02:07 AM

Uncompressing Linux... done, booting the kernel then stopped
 
Hi,
I am using linux kernel 2.6.33...version kernel
My hardware board is at91rm9200dk .
I am using Uboot 1.3.4 version
Compiled and transfered the uImage in to the custom board then it shows
an message and stops ....it is not going ahead
..
Image Name: Linux-2.6.33.3
Image Type: ARM Linux Kernel Image (uncompressed)
Data Size: 937844 Bytes = 915.9 kB
Load Address: 20008000
Entry Point: 20008000
Verifying Checksum ... OK
Loading Kernel Image ... OK
OK
Starting kernel ...
Uncompressing Linux... done, booting the kernel.
What will be the reason ?
a) Is this problem of Kernel
b) Is this problem of kernel configuration ?
Note:
While compiling the kernel
Image Name: Linux-2.6.33.3
Created: Thu Jul 8 16:10:54 2010
Image Type: ARM Linux Kernel Image (uncompressed)
Data Size: 937844 Bytes = 915.86 kB = 0.89 MB
Load Address: 0x20008000
Entry Point: 0x20008000
Image arch/arm/boot/uImage is ready
[root@UcontestPC linux-2.6.33.3]#
a) what is load address and entry point ....Is there any relation with this problem
Please help me
Thanks By
RRNAIR

jf.argentino 07-09-2010 12:36 PM

Maybe try to force the kernel console by adding the following argument to the kernel: "console=ttyS0,115200", you have to adapt it depending on your tty device name (I'm supposing this board use a serial console).

zaks_974 07-19-2010 03:03 AM

Reduce the bigphysarea and try. It is the problem with bigphysarea


All times are GMT -5. The time now is 11:53 PM.