I have a problem when I followed the stage 1 install guide and when I come to genkernel. This is a summary of what I have done... partitions (1ntfs, 1boot, 1root, 1swap), network up, did tar -xvjpf stage1, chroot, emerge sync, make.conf, emerge sys, fstab
Now this is where my problem starts..
Code:
emerge -k gentoo-sources
emerge -k genkernel
genkernel
**doesnt work**
emerge -k sys-kernel/gentoo-sources
emerge -k genkernel
genkernel
**doesnt work**
emerge -k gentoo-sources
emerge -k genkernel; genkernel
** doesnt work**
Those three were three different installations I have done (because each time I thought i missed something when I installed, so I did it over AT LEAST three times)
The problem is what happened after I tried genkernel this is what I see on the screen, and this isnt supposed to happen in the installation guide. I am not sure what do with the options so if you know how to make the options work I would appreciate it.
genkernel output:
Code:
--no-color Do not output debug in color
Kernel Compile setting
--menuconfig Run menu config after oldconfig
--no-menuconfig Do no run meny config after oldconfig
--mrproper Run make mrproper before compilation
--clean Run make clean before compilation
--no-clean Do not run make clean before compilation
And the list contines to Low-Level Compile Settings, internals, misc settings, outpur settings.. I would think these options are available onthe internet.
I have no idea what to do