iptables state module not loaded error

rnj · 10-27-2004, 10:17 PM

hi,

I am trying to setup an ip table script for an internal lan connected to a server. I have to issues

1. when i run iptables...it says the state module is not found or loaded?
2. Can i used nat on a single ethernet interface using sub interfaces
eth0:0 and eth0:1? if so, please suggest a simple how to?

Thanks in advance.

Regards,
RnJ

misc · 10-28-2004, 05:41 AM

Quote:

1. when i run iptables...it says the state module is not found or loaded?

Please give a command-line session example (including full input and output). Also include output of "rpm -q iptables kernel ; rpm -V iptables kernel".

Quote:

2. Can i used nat on a single ethernet interface using sub interfaces
eth0:0 and eth0:1? if so, please suggest a simple how to?

Device alias notation is not supported. Filter on eth0 and the proper network address.

rnj · 10-28-2004, 11:33 PM

hi

Can I do NAT with one nic card. Can I set private ip to eth0:0 and global ip to eth0:1 and do the nat. If this is possible ..please suggest as to how????

ifconfig?????/
iptables -nat ????

Thx in advance.

RnJ