How do you check if eth0 is set to half/full duplex.
How do you set eth0 to half/full duplex.

Thanks
Jim

I should have Googled It, The correct command is .
My eth0 shows status below.
Jim


# /sbin/ethtool eth0
Settings for eth0:
Supported ports: [ TP MII ]
Supported link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
Supports auto-negotiation: Yes
Advertised link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
Advertised auto-negotiation: Yes
Speed: 100Mb/s
Duplex: Full
Port: MII
PHYAD: 24
Transceiver: internal
Auto-negotiation: on
Current message level: 0x00000001 (1)
Link detected: yes

Thanks.
Did this help big time.