Originally Posted by jabka

Hello ...
im use to use ifup eth0 to configure my network card.
but when i try to use this i get unknown device eth0.
there is a device "lo".

i can connect to the net by using iwiz(internet wizzard).

Originally Posted by root

root@2[knoppix]# ifconfig eth0 up
root@2[knoppix]# ifup eth0
Ignoring unknown interface eth0=eth0.
root@2[knoppix]# ifconfig
eth0 Link encap:Ethernet HWaddr 00:16:D4:16:95:8C
inet addr:172.24.38.202 Bcast:255.255.255.255 Mask:255.255.224.0
UP BROADCAST RUNNING MULTICAST MTU:576 Metric:1
RX packets:2273 errors:0 dropped:0 overruns:0 frame:0
TX packets:2647 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:1527909 (1.4 MiB) TX bytes:554913 (541.9 KiB)
Interrupt:19 Base address:0xe000

lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:14 errors:0 dropped:0 overruns:0 frame:0
TX packets:14 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:700 (700.0 b) TX bytes:700 (700.0 b)

ppp0 Link encap:Point-to-Point Protocol
inet addr:84.94.136.54 P-t-P:212.199.26.110 Mask:255.255.255.255
UP POINTOPOINT RUNNING NOARP MULTICAST MTU:1452 Metric:1
RX packets:2045 errors:0 dropped:0 overruns:0 frame:0
TX packets:2158 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:3
RX bytes:1372794 (1.3 MiB) TX bytes:418340 (408.5 KiB)