rhraz

[Log in to get rid of this advertisement]

Mandrake picked up the card fine. I installed the Linux driver from nvidia.com to get 3d acceleration (driver has to be run in command prompt to work). It was pretty painless, and I'm a complete newbie!. :)

Bebo

I have the Ti 500 version of this card, with lspci output

VGA compatible controller: nVidia Corporation NV20 [GeForce3 Ti 500] (rev a3) (prog-if 00 [VGA])

I use nVidia's driver, which you can get from nVidia's web page. As of recently, the 2.6.x kernels are supported. Some poking in /etc/XF86Config(-4) is necessary. Graphics acceleration works fine, and with this computer (a P4 1.9 GHz and 1 gig RAM) I get about 2300 FPS.

nVidia's GeForce web page: http://www.nvidia.com/page/geforce3.html

Two reviews:
http://www.tweak3d.net/reviews/nvidia/gf3ti500/
http://www.amdmb.com/article-display.php?ArticleID=142

Schrambo

Leadtek Geforce 3 ti 200 TDH to be exact. = winnah, no problems at all

Manini

I have the Visiontek Geforce 3 Ti 200. Works without a flaw on many of the distros I've used. I needed to install the nvidia drivers for 3d acceleration, but other than, it runs great without any problems.